Epson WF-2540

These are general instructions for the Epson Wf-2540

Copy Quality is the quality of the printer prints when making a copy. Sometimes the settings might need to be set back to standard. Here are the steps.

• Look at the main display for the printer. You will be navigating with the arrows, pressing OK at the center of the arrows, and pressing the “Menu” button below the arrows.
• Press settings (menu)
• Choose “Paper and Copy settings” and Press OK
• Choose “Layout” and press OK
• Chosoe “With border” and press OK
• You are now back in the “Paper and copy settings”
• Choose “Paper Type” and press OK
• Choose “plain paper” and press OK
• You are now back in the “Paper and copy settings”
• Choose “Quality” and press OK
• Choose “Standard Quality” and press OK
• You can now exit by pressing the Menu button for “Done”

If the print quality changes to photo or something undesirable it can make printing slow and take up a lot of ink. Sometimes this can be changed as an error and you must revert it back manually. Here is how:

• WORK IN PROGRESS

Enlarging small documents should be a matter of putting them on the tray. However if you want to enlarge already large documents you may need to use some trial and error with where you place them on the scanner platter.

• Place document on the scanner
• Press the “Menu” button
• Use the arrows to find: “Paper and copy settings” Press Ok at the center of the arrows.
• Find “Reduce/enlarge” Press OK
• Find “Custom size” Press OK
• Press Up and down to change percentage
• Press OK when done
• Press Menu when done
• !!IMPORTANT!! Do not forget to set the percentages back to 100 when completed.